D-Link DI-304M - Manual (Page 83)

DI-304/DI-304M ISDN Remote Router
♦ Refresh – To obtain the latest information, click here to reload the page.
ISDN
♦ ISDN Link Status – If the link is active, this field will show up .
Otherwise, it shows down .
♦ Dial ISDN – Clicking here causes the router to dial to the preset ISP.
Click Internet Access Setup → Dial to a Single ISP to configure dial-up
settings.
♦ Activity – Displays the connection name for each B channel. If the B
channel is idle, it will show Idle.
◊ Drop B1 - Click to disconnect the B1 channel.
◊ Drop B2 - Click to disconnect the B2 channel.
Broadband Access
♦ Broadband Access Mode/Status – Displays the broadband access mode
and status. If the broadband connection is active, it will show PPPoE,
PPTP, or Static IP depending on which access mode is enabled. If the
connection is idle, it will show "- - -".
♦ WAN IP Address – The WAN IP address for the active connection.
♦ Dial PPPoE or PPTP – Click to force the router to establish a PPPoE or
PPTP connection.
♦ Drop PPPoE or PPTP – Click to force the router to disconnect the
current active PPPoE or PPTP connection.
Triggered Dial-out Packet Header
Triggered Dial-out Packet Header shows the last IP packet header that triggers the
router to dial out.
75