Load from disk – Hypertherm HTA Rev 6.00 Operators Manual User Manual

Page 87

Section 5: Files

Section 5: Files

Load from Disk

The following screen is used to load a part from a diskette or the hard drive. Once all the parameters
below are set, press ENTER on the keyboard to load the part.

Load from
The Load from list selects whether you load from the diskette or from a directory on the hard disk. To
select a different directory, use the

↑ and ↓ keys on the keyboard. To add a new directory, use the +

key on the keyboard. To remove a directory, use the - key on the keyboard.

Files
The Files listbox is a list of all the files that are in the Load from directory that can be loaded from the
disk. To scroll through different files, use the

↑, ↓, PAGE UP and PAGE DOWN keys on the

keyboard. To remove a file, use the - key on the keyboard. To select multiple files to load, highlight
the first file selection, then use the

↑ and ↓ keys while pressing the shift key to highlight the remaining

files. Note: Multiple file selection is only available if loading from the diskette to the hard drive.

This manual is related to the following products:

HTA Rev 5.00 Operators Manual HTA Rev 4.00 Operators Manual