Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 162)

148 Operator’s Manual
Setups
Cut Types
The Cut types setup screen is similar to those previously outlined in this guide with the exception
that the Mariner ™and Voyager II™ Controls offer multiple Plasma and Marker process screens.
Use Plasma 1 Data
The Use Plasma 1 Data setup parameter is used to force all Plasma 2 process setup parameters
to use the Plasma 1 process timing data. This allows simple modification to both Plasma setup
screens when both Plasma systems being used are similar and require the same process timing.
Use Marker 1 Data
The Use Marker 1 Data setup parameter is used to force all Marker 2 process setup parameters
to use the Marker 1 process timing data. This allows simple modification to both Marker setup
screens when both Marker systems being used are similar and require the same process timing.