Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 44)

30 Operator’s Manual
Oxy Fuel
The control comes with the following built-in control logic for Oxy Fuel cutting. When Oxy Fuel is
selected, the following parameters are available to customize the logic for the particular metal being
cut. As these parameters are changed, the timing diagram below will change to show the new timing
parameters. This screen is located under the Cut Types softkey in the Setups.
Note: Pressing the Start key twice will bypass all timers and begin the cut.
I/O Configuration Type “M”, “P” and “V”
I/O Configuration Type “M”, “P” and “V”
Press the Space Key to view the timing diagram from setups.