Hypertherm HTA Rev 6.00 Operators Manual - Manual (Page 178)

164 Operator’s Manual
HD3070 ® Auto Gas Interface
This section outlines information specific to Hypertherm’s HD3070 ® Auto Gas Interface. The
Auto Gas screen is available from the Cut Types screen.
Note: The Auto Gas feature must first be enabled at the Special Password screen.
The top of the Auto Gas screen lists the valve parameter settings for the HD3070
® . Valve
settings for the 3070 ® Auto Gas console are documented in the HD3070 ® manual. When the
values are set, these become the current setting and the operator can choose to save the file to
the diskette or hard drive.
The settings at the supply are updated at control power up, whenever the settings are changed at
this screen or through commands in a part program Supply settings are also updated if power
is lost and re-enabled at the power supply. There may be a brief delay as these power supply
settings are communicated from the control to the power supply.
Save Data
Pressing the Save Data softkey will allow the operator to save the current Auto Gas setting to
diskette or hard drive for future use.
Load Data
Pressing the Load Data softkey will allow the operator to Load stored Auto Gas settings from
diskette or hard drive for use.