Harken 7320.10 ESP Jib Reefing & Furling - Manual (Page 30)

30 ESP Unit 0, 1
Operation Adjust Turnbuckle
Adjust Turnbuckle
Tools: See page 6 for sizes
Wrench for locknuts
Allen wrench
Slotted screwdriver for foil screws
Sidecutters for cotter pins
Tip: Tape a flat cardboard box or a towel
under the furler to catch any dropped
parts.
Attach halyard to tack shackle, take out
slack and secure.
Remove feeder screw and one foil screw.
While holding foils up, carefully remove
screw and lower foils to drum assembly.
Tip: Have a helper lift foils and hold or
use another halyard while removing last
screw. To use a halyard to hold foils
lifted, tie a rolling hitch to the foils using
another line or use the actual halyard if
suitable. See www.harken.com/knots
for tying resources.
CAUTION! Foils have considerable
weight and can drop and cut hands
if placed underneath. Make sure
foils are securely held up while
adjusting turnbuckle.
Carefully loosen nut enough to move
legs outwards and rotate out
of the way. When reassembling, you
must secure flats on both parts. See
assembly step 19a, (page 20).
Carefully remove plastic collar
and screws.
Do not drop.
Loosen screws and separate legs
from flats on crosspin. Rotate legs
so they are laying on the deck.
IMPORTANT! Parts are easily lost.
Unlock turnbuckle and adjust.
Lock turnbuckle and reassemble
leg kit parts.