Harken 7000 Carbo Racing Foil - Manual (Page 5)

Installation
Unit 0, 1, 2, 3 Carbo Racing Foil 5
5. Feeder
Slip feeder into place and firmly push upwards.
Coat screw with blue Loctite ® and tighten.
If screw does not thread, check alignment
.
6. Bottom Tube
Push foil up as far as it will go.
Measure length from feeder to bottom of
exposed stay for lower spacer tube length.
Cut, splay, and snap tube into place.
Tape full length of lower spacer tube.
7. Prefeeder
Measure 12" (300 mm) below feeder and
lash prefeeder to tube.
Tape prefeeder in place.
Loctite is a trademark of Henkel AG & Company KGaA.