Harken 7000 Carbo Racing Foil - Manual (Page 4)

Splay 5" (127 mm) upper spacer tube with flat
bladed screwdriver, slip onto stay and tape.
1. Upper Spacer Tube
Important: Tape full length of spacer tube.
2. Foil Start
Identify top of foil. Side groove will be
on starboard.
Tip: In cool
weather, use
a heat gun
to warm foil.
Tip: Foil installs easier if excess is held out
to starboard side of boat.
3. Trim Cap
Place trim cap on foil so slot is aft, with
large hole on starboard. Squeeze together
with pliers. Put blue Loctite ® in barrel nut.
Install two-piece screw and barrel nut with
Phillips screwdriver.
4 Unit 0, 1, 2, 3 Carbo Racing Foil
4. Foil
Snap foil into place by pulling aft with one
hand, while sliding foil up with the other.
Use heat gun.
Tip: Use liquid soap to lubricate headstay
and foil.
Splay foil with screwdriver and pull onto
stay. Once foil is started, stop to install
trim cap.
Installation
IMPORTANT! Do not use McLube
to lubricate headstay and foil.
See Maintenance on Page 8
for details.
Loctite is a trademark of Henkel AG & Company KGaA.