Grandstream GXW400x User Manual - Manual (Page 49)

FIRMWARE VERSION 1.0.14.1 GXW400X USER MANUAL Page 47 of 60
Use SIP User-Agent
Header
Used to replace SIP User-Agent Header (No Default)
Distinctive Ringtone Custom Ring Tone 1 to 3 with associate Caller ID: when selected, if Caller ID is
configured, then the device will ONLY uses this ring tone when the incoming call is from
the Caller ID. System Ring Tone is used for all other calls. When selected but no Caller
ID is configured, the selected ring tone will be used for all incoming calls. Distinctive ring
tones can be configured not only for matching whole number, but also for matching
prefixes. In this case symbol * (star) will be used.
If server supports Alert-Info header and standard ring tone set (Bellcore) or distinctive
ring tone 1-10 is specified, then the ring tone in the Alert-Info header from server will be
used.
For example:
If configured as *617, Ring Tone 1 will be used in case of call arrived from
Massachusetts. Any other incoming call will ring using cadence defined in parameter
System Ring Cadence located under Advanced Settings Configuration page.
Disable Call Waiting Default is No. If set to YES Call Waiting indication information will not be provided to
analog phone connected to this FXS port.
Disable Call Waiting
Caller ID
Default is No. If set to YES Call Waiting caller ID will not be provided to analog phone
connected to this FXS port.
Disable Call Waiting
Tone
Default is No. This is to disable the stutter Call Waiting Tone when a Call Waiting call
arrives. The CWCID will still be displayed.
Disable Reminder
Ring for On-Hold Call
Default is No. This is to disable the Reminder Ring that is played when a call is waiting
on hold and the analog phone goes on-hook.
Disable Visual MWI Visual message indicator is a special on-hook caller ID type message that enables and
disables the message waiting light on certain phones. GXW400X has this feature
enabled by default. However, certain phones (rare) that do not support it may mistakenly
treat this CID signal as an incoming call. A configuration option is needed to turn on MWI
in this case.
Do Not Escape '#'
as %23 in SIP URI
If set to “Yes”, device will use ‘#’ instead of %23 in the send URI.
Disable Multiple m line
in SDP Default is No. If set to Yes, device will send only one m line in SDP, regardless how
many m field in the incoming SDP.
Ring Timeout Incoming call will stop ringing when not picked up given a specific period of time.