Grandstream GXW400x User Manual - Manual (Page 29)

FIRMWARE VERSION 1.0.14.1 GXW400X USER MANUAL Page 27 of 60
CONFIGURATION GUIDE
CONFIGURING GXW400X VIA VOICE PROMPT
DHCP M ODE
Select voice menu option 01 to enable GXW400X to use DHCP.
STATIC IP M ODE
Select voice menu option 01 to enable GXW400X to use STATIC IP mode, then use option 02, 03, 04, 05
to set up IP address, Subnet Mask, Gateway and DNS server respectively.
F IRMWARE S ERVER IP A DDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
C ONFIGURATION S ERVER IP A DDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
U PGRADE P ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F IRMWARE U PGRADE M ODE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) always check, 2) check when pre/suffix changes, and 3) never upgrade
WAN P ORT W EB A CCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.
CONFIGURING GXW400X WITH WEB BROWSER
The GXW400X series gateway has an embedded Web server that allows users to configure the
GXW400X through a web browser.