Grandstream GXW400x User Manual - Manual (Page 19)

FIRMWARE VERSION 1.0.14.1 GXW400X USER MANUAL Page 17 of 60
BASIC OPERATIONS
UNDERSTANDING GXW VOICE PROMPTS
GXW400X has a built-in voice prompt menu for simple device configuration. To enter the voice prompt
menu, press *** on the standard analog phone connected to any FXS port.
TABLE 5: DEFINITIONS OF THE GXW VOICE PROMPTS
Menu Voice Prompt User’s Options
Main Menu “Enter a Menu Option” Enter “*” for the next menu option
Enter “#” to return to the main menu
Enter 01 – 05, 07,10 - 17, 47, 86 or 99 Menu option
01 “DHCP Mode”, “PPPoE
Mode ”or “Static IP Mode”
Enter ‘9’ to toggle the selection
If user selects “Static IP Mode”, user need configure all the IP
address information through menu 02 to 05. If user selects
“Dynamic IP Mode”, the device will retrieve all IP address
information from DHCP server automatically when user reboots
the device.
02 “IP Address “ + IP address The current WAN IP address is announced
Enter 12-digit new IP address if in Static IP Mode.
03 “Subnet “ + IP address Same as Menu option 02
04 “Gateway “ + IP address Same as Menu option 02
05 “DNS Server “ + IP address Same as Menu option 02
07 Preferred Vocoder Enter “9” to go to the next selection in the list:

PCM U

PCM A

iLBC

G-726

G-723

G-729
10 “MAC Address” Announces the Mac address of the unit.
12 WAN Port Web Access Enter “9” to toggle between enabled and disabled
13 Firmware Server IP
Address
Announces current Firmware Server IP address. Enter 12 digit
new IP address.
14 Configuration Server IP
Address
Announces current Config Server Path IP address. Enter 12 digit
new IP address.