Grandstream GXV3175 User Manual - Manual (Page 62)

FIRMWARE VERSION 1.0.3.76 GXV3175 USER MANUAL Page 62 of 139
any length of numbers with leading digit 2, replacing the 2 with 011 when
dialed.
3. Default: Outgoing – { x+ | \+x+ | *x+ | *xx*x+ }
Allow any number of digits, OR any number with a leading +, OR any
number with a leading *, OR any number with a leading * followed by a 2
digit number and a *. To dial + from keypad, press on 0 until + appears on
LCD.
Example of a simple dial plan used in a Home/Office in the US:
{ ^1900x. | <=1617>[2-9]xxxxxx | 1[2-9]xx[2-9]xxxxxx | 011[2-9]x. | [3469]11 }
Explanation of example rule (reading from left to right):
• ^1900x. - prevents dialing any number started with 1900
• <=1617>[2-9]xxxxxx - allow dialing to local area code (617) numbers by
dialing
7 numbers and 1617 area code will be added automatically
• 1[2-9]xx[2-9]xxxxxx |- allow dialing to any US/Canada Number with 11
digits
length
• 011[2-9]x. - allow international calls starting with 011
• [3469]11 - allow dialing special and emergency numbers 311, 411, 611 and
911
NOTE: In some cases where the user wishes to dial strings such as *123 to
activate voice mail or other applications provided by their service provider,
the * should be predefined inside the dial plan feature. An example dial plan
will be: { *x+ } which allows the user to dial * followed by any length of
numbers.
Early Dial The default setting is No. Use only if the proxy supports 484 response.
Refer to Use Target
Contact
The default is No. If set to Yes , then for Attended Transfer, the “Refer-To”
header uses the transferred target’s contact header information.
Auto Answer The default setting is No. If it is set to Yes, the GXV3175 will play a “beep”
sound and answer the phone automatically on the speaker. If “Enable
Intercom/Paging” option is selected, phone will auto answer calls when the
“call-info” header contains “answer-after=0” in the incoming INVITE.
Send Anonymous If set to Yes, the “From” header in the outgoing SIP messages will be set to
anonymous to block the caller ID from displaying. The default setting is No.
Anonymous Call Rejection The default setting is No；If set to Yes，any anonymous call will be rejected
（with 486 Busy message）