Grandstream GXV3175 User Manual - Manual (Page 57)

FIRMWARE VERSION 1.0.3.76 GXV3175 USER MANUAL Page 57 of 139
SIP account has an individual configuration page.
Account/General Settings
Account Active Select Yes to enable and use the Line.
Account Name The account name for the user that is displayed on the LCD screen.
SIP Server The IP address of the SIP server or the given domain name of the VoIP
service provider.
SIP User ID User account information provided by the VoIP service provider; normally
similar to a telephone number or an actual telephone number.
Authenticate ID The authenticate ID for the SIP user. It can differ or be the same as the SIP
user ID.
Authenticate password The password that the GXV uses to authenticate with the ITSP (SIP) server.
After it is saved, this will appear as blank for security reasons. The
maximum length is 25 characters.
Voice Mail User ID When this is configured, the user can dial to the voicemail server using the
MESSAGE button. This ID is normally the feature code for Voice Mail.
Name The Caller ID that will be displayed for the account.
Tel URI The default setting is “Disable”. If the Video phone has an assigned PSTN
number, this field should be set to “Enable”. If “User=Phone” is set, a
“User=Phone” parameter will be attached to the “From header” in the SIP
request to indicate the E.164 number.
Account/Network Settings
Outbound Proxy IP address or Domain name of the Outbound Proxy, or Media Gateway, or
Session Border Controller. Used by the GXV3175 for firewall or NAT
penetration in different network environments. If a symmetric NAT is
detected, STUN will not work and ONLY an Outbound Proxy will work.
Secondary Outbound
Proxy
IP address or domain name of a backup Outbound Proxy.
DNS Mode The default is set to A Record. If the user wishes to locate the server by DNS
SRV, the user may select SRV or NATPTR/SRV.
NAT Traversal This setting decides whether the NAT traversal mechanism is activated. If it
is set to “STUN” and STUN server is configured, the GXV3175 will route
according the STUN server. In this mode, the STUN client embedded in the
phone will communicate with the appointed STUN server to examine which
type of Firewall/NAT setting is employed. If the type of NAT detected is Full
Cone, Restricted Cone or Port-Restricted cone, the phone will try to use