GAI-Tronics ICP9000 Navigator Series Console Installation and Service Manual - Manual (Page 52)

Console Diagnostics ICP9000 Navigator Installation and Service Manual
12/10 48
Start-Up Display
Boot-Up Error Code Definitions
The following error codes are displayed automatically upon boot-up:
Master – 00
If anything other than 00 is displayed for the master error, contact GAI-Tronics field service.
Slave – 00 00 00
00 = OK
01 = Slave not present
02 = Slave malfunction
04 = Slave malfunction
06 = Slave malfunction
80 = Slave malfunction
Options Code Definitions
Any options that are installed are identified by the option codes in the information window. They are as
follows:
• ENC = Paging Encode • MLS = Multi-Line Select
• SLT = STAT-ALERT (MDC1200) • MFQ = Multi-Frequency
• PMC = Positive Mode Control • CDC = DC Option
• DEC = DTMF Decode • E&M = E&M Option
• SUP = Supervisory Control • CTH = Full Duplex Phone Board (External Interface)
• CTI = Telephone Interface (Direct)
CARD Suite Software Version
Version x.x.x : The CARD Suite version that programmed the console.
Firmware Version – Host – DSP – Display CPK
Firmware Version: NAVXX HNAVXX MASTXX