GAI-Tronics ICP9000 Navigator Series Console Installation and Service Manual - Manual (Page 20)

Installation ICP9000 Navigator Installation and Service Manual
12/10 16
Types of Base Station Control
The ICP9000 Navigator is capable of either tone or dc control depending on the position of jumpers
JU620 through JU623. For dc control, the console must have option CP0010 or XCP0010A. Refer to
Table 2.
Table 2. Jumper Positions for DC or Tone Control Selection
Function Jumper No. Position
Ch. 1, 5, 9 JU620 IN
OUT
Tone Control
DC Control (option CP0010 or XCP0010A)
Ch. 2, 6, 10 JU621 IN
OUT
Tone Control
DC Control (option CP0010 or XCP0010A)
Ch. 3, 7, 11 JU622 IN
OUT
Tone Control
DC Control (option CP0010 or XCP0010A)
Ch. 4, 8, 12 JU623 IN
OUT
Tone Control
DC Control (option CP0010 or XCP0010A)
N OTE : If operating in dc mode, the console must also be programmed for dc under Type of Interface in
the CARD Suite Software.
Two Wire Control (default)
In this configuration, a single two-wire line is used to carry the control tones or dc control currents (as
applicable per channel) and the transmitter audio, from the ICP9000 Navigator to the base station. This
same 2-wire line is used to return the receive audio back to the console from the base station. Refer to
Table 3 for the appropriate system configuration.
Four Wire Audio/Control
In this configuration, one pair of lines is used to carry both control tones or dc control currents (as
applicable per channel) and the transmitter audio from the ICP9000 Navigator to the base station. The
other pair is used to carry the receive audio from the base station back to the console. Refer to Table 3 for
the appropriate system configuration.
N
OTE : In this configuration, RX audio can still be received on original 2-wire pair.
Table 3. Slave Module – 2-Wire/4-Wire
Function Jumper No. Position
Ch. 1, 5, 9 – 2W/4W Select JU602 2W – 2 wire control
4W – 4 wire control
Ch. 2, 6, 10 – 2W/4W Select JU606 2W – 2 wire control
4W – 4 wire control
Ch. 3, 7, 11 – 2W/4W Select JU610 2W – 2 wire control
4W – 4 wire control
Ch. 4, 8, 12 – 2W/4W Select JU614 2W – 2 wire control
4W – 4 wire control