GAI-Tronics VoIP Basic Programming Guide - Manual (Page 8)

Pub. 42004-481B
VoIP Telephone Basic Programming Guide Page 7 of 28
f:\standard ioms - current release\42004 instr. manuals\42004-481b.doc
10/13
Table 2. SIP 1 Settings Sub-Page Parameters needed for basic configuration
Parameter Function
LOCALID &
DOMAIN Together, these set the URI (uniform resource identifier) of the telephone. In the
example shown in Figure 3, the URI would be
sip:[email protected]
These values are used in the To:, From:, and Contact: headers, and also in the
registration process with a registrar.
Any alphanumeric string is accepted.
Default values (both):
blank
PROXY
Sets the IP address or the FQDN of the SIP proxy server to be used for
incoming/outgoing calls.
Default value:
blank
PROXYPORT Sets the port number on the proxy used for SIP protocol signaling.
Default value:
5060
PRIORITY Sets the failover sequence among the four SIP sub-pages.
Set to
1 .
REGISTRAR Sets the address of the Registrar, either as an IP address or FQDN. The registrar
address and the proxy may or may not be the same, but the address for
registration must be set here.
Default value:
blank
REGISTRARPORT Sets the port number where the requests will be sent.
Default value:
5060 or unspecified.
USERNAME Sets the username for the registrar authorization realm.
Default value: blank
PASSWORD Sets the password for the registrar authorization realm.
Default value: blank
ENDPOINT Sets whether the sub-page is ENABLED or DISABLED.
Default value:
ENABLED for SIP1 (All others: DISABLED).
Next, under the Network heading, click the link for Unit Settings to navigate to the Unit Settings page.