GAI-Tronics VoIP Basic Programming Guide - Manual (Page 15)

Pub. 42004-481B
VoIP Telephone Basic Programming Guide Page 14 of 28
f:\standard ioms - current release\42004 instr. manuals\42004-481b.doc
10/13
The telephone auto-dial memory buttons are pre-configured from the factory. Only the destination
telephone numbers or addresses (Memory) must be entered, and the comfort string, if desired.
Click the Edit button to begin making changes. Click the Apply & Save button to save your changes
when complete.
Table 6.
Parameter Function
MEMORY Each of the 20 possible entries can be a string of dial-able characters (such as a
telephone number) or a SIP URI.
Dial-able characters are the digits 0–9, and the letters A, B, C, and D.
COMFORT
Each of the 20 possible entries can also be assigned a COMFORT string, which is a
string of digits that will be played back to the user as DTMF when the call is being set
up. This simulates the dialing digit tones heard on a normal telephone. If these comfort
digits are required, the comfort string must be entered, even if the memory itself is a
number.
N OTE : These memories (usually telephone numbers or addresses) are not assigned directly to the
Emergency button. They must be set up in Memory Lists sub-page. Click on the Memory Lists link to
navigate to the Memory Lists sub-page.