GAI-Tronics 293-700 VoIP Telephone - Manual (Page 18)

P UB . 42004-397G
V O IP T ELEPHONES P AGE 16 of 23
f:\standard ioms - current release\42004 instr. manuals\42004-397g.doc
11/09
Programming
Refer to Pub. 42004-396, VoIP Telephone Configuration Guide for detailed programming and
configuration instructions.
Quick Start Guide
The general sequence for set up and use is:
Stage of Process Comments
Initial network configuration Essential: Each phone must be set up for the network prior to
installation.
Assign a host name Recommended: The host name provides identification of the different
VoIP phones on the network.
Change user name and
password Recommended: This security measure helps to prevent unauthorized
changes to the phone’s configuration.
Mounting Physically mount the phone at the intended location.
Installation Provide phone connections and cabling to the network at the intended
location.
Final configuration (can also
be done prior to installation) Set the autodial numbers, etc. Configuration changes can be performed
remotely, if desired.
Test Verify that calls can be made successfully.
Maintain Monitor alarms. Set up auto-updates.
The easiest way to get started is to make a network connection to the unit and log on via a web browser.
The unit is initially set with a static IP address:
IP address 192.168.1.2
A user name and password will be requested. The initial factory settings are:
User Name user
Password password
The phone’s home page is as shown below, and allows access to all the other configuration pages. Use
the Network page to change IP settings appropriate for the intended network.