Foxconn X38A - Manual (Page 77)

71
Chapter 5 RAID Configuration
3. Press to switch to “RAID Level” item, and then use Up or Down arrow
key to select RAID1 (Mirror), press to confirm.
4. Select “Disks” item and press to choose the hard disks that you want
to configure as RAID 1.
5. key in the RAID volume “Capacity” value, then Press . The default value
indicates the maximum capacity.
6. Select “Create Volume” and Press , a warning message will appear
as below:
Press to create the volume and return to the main menu.
Press to return to the “Create RAID Volume” menu.
1. Select “1.Create RAID Volume” from the utility main menu and press .
2. Key in a name for the RAID 10 according to the [DISK/VOLUME INFORMATION]
and press to confirm.
Creating RAID 10 (0+1)
Attention:
You will lost all data on the selected hard disk when you press
to create the volume.
3. Press to switch to “RAID Level” item, and then use Up or Down arrow
key to select RAID10 (RAID 0+1), press to confirm.
4. Select “Disks” item and press to choose the hard disks that you want
to configure as RAID 10.
5. Use Up or Down arrow keys to select desired strip size for RAID10. The avail-
able values range from 4KB to 128KB. The default value is 64KB.
16K_Best for sequential transfer
64K_Good general purpose strip size
128K_Best performance for most desktops and workstations
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn