Foxconn X38A User Manual

Page 27

Chapter 2 Installation Instructions

INTRUDERJ

GND

INTR

Jumpers

This section explains how to setup jumpers. You should read the following
content carefully prior to modifying any jumper settings.

Clear CMOS Jumper: CLR_CMOS
The CLR_CMOS jumper allows you to clear the data in CMOS. The data
includes system setup information such as system password, data, time,
and system setup parameters. To clear and reset the system parameters to
default setup, please do as follows:

The jumpers on the motherboard, pin 1 can be identified by the
bold silkscreen next to it. and in this manual, pin 1 is simply la-
beled as “1”.

Attention

1. Turn off the computer and unplug the power cord from the power supply.
2. Move the jumper cap from pins 2-3 (default) to pins 1-2. Keep the cap on
pins 1-2 for several seconds, then move the cap back to pins 2-3.
3. Plug the power cord and turn on the computer, press to enter BIOS
setup during POST to load defaults.

CLR_ CMOS

Clear CMOS Jumper

Chassis Intruder Connector

Normal

(default)

Clear

PDF 文件使用 "pdfFactory" 试用版本创建