Foxconn X38A - Manual (Page 33)

27
Chapter 3 BIOS Description
2.1 IDE Configuration
Scroll to this item and press to view the following screen:
IDE Configuration Menu
v SATA#1 / SATA#2 Configuration
This item is used to configure SATA 1 / SATA 2.
v Configure SATA#1 as
The option uses to set the type of SATA.
v Primary / Secondary / Third / Fourth / Fifth / Sixth IDE Master &
Primary / Secondary /Sixth IDE Slave
Leave this item at auto to enable the system to automatically detect and con-
figure IDE device on the channel. Press to access its sub menu.
v Hard Disk Write Protect
Set this item to protect the hard disk drive from being overwritten.
v IDE Detect Time Out (Sec)
This item is used to stop the BIOS from searching for IDE devices within the
specified number of seconds. Basically, this allows you to fine-tune the set-
tings to allow for faster boot times. Adjust this setting until a suitable timing
that can detect all IDE disk drives attached is found.
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn