Foxconn X38A - Manual (Page 75)

69
Chapter 5 RAID Configuration
2. Enter a name for the RAID 0 according to the [DISK/VOLUME INFORMATION]
and press to confirm.
3. Press to switch to “RAID Level” item, and then use Up or Down arrow
key to select RAID0 (Stripe), press to confirm.
4. Select “Disks” item and press to display the [SELECT DISKS] screen
shown as below:
5. using up or down arrow key to select the hard disks you want to configure as
RAID 0 from the list, then press key to confirm, and key to
finish the selection.
6. Use Up or Down arrow key to select desired strip size when enter “Strip Size”
menu. The available values range from 4KB to 128KB. The strip value should
be based on the planned drive usage. Some suggested selections are listed
below. The default value is 128KB.
16K_Best for sequential transfer
64K_Good general purpose strip size
128K_Best performance for most desktops and workstations
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn