Foxconn Bloodrage - Manual (Page 26)

19
2
FAN1/2
GND
+12V
SENSE 1
CPU_FAN1
SYS_FAN1
GND
POWER
SENSE
CONTROL
1
SATA_1-2/3-4/5-6
GND TX+
TX-
GND
RX-
RX+ GND
1
RESET
5V
ISP
GPIO
EMPTY GPIO
GPIO SDA
3.3V SCL
NC RXD
GND TXD
VFD
1 2
13 14
GND
TX+
TX-
GND
RX-
RX+
GND
1
SAS_SATA_1/2
fan Connectors : CPU_fAN1, sYs_fAN1,
fAN1/2
There are four fan headers on this motherboard. These
fans can be automatically turned off after the system
enters S3, S4 and S5 sleeping states.
sAs_sATA Connectors : sAs_sATA_1/2
The SAS_SATA connectors support both SATA and SAS
(Serial Attached SCSI) Hard Disks. Use the bundled SAS
cables to connect either a SAS or SATA HDD to these
connectors
serial ATA Connectors : sATA_1-2, sATA_3-4,
sATA_5-6,
The Serial ATA connector supports SATA Hard Disks,
SSDs and optical Drives. The current Serial ATA II
interface allows up to 300MB/s data transfer rates per
channel.
VfD Connector : VfD
The VFD Connector can be connected to the Foxconn
QuantumForce OC Panel, which can be installed in any
standard 5.25" optical drive bay. It can be used to display
the Port80 Debug codes during Bootup, display the system
Real Time Clock, display the system temperatures as well
as monitor and adjust System voltages and clockspeeds
on the fly. With several buttons located on the front panel,
you can easily set the Front Side Bus speed, adjust CPU,
DRAM and VTT NB voltage and change the fan speeds.
It supports profiles which can be loaded within fractions of
a second by pushing a single button. You can purchase
it to overclock your system on the fly, switch from one oc
profile to another during a benchmark, switch from gaming
mode to cinema or silent mode.