Foxconn C51XEM2AA-8EKRS2H - Manual (Page 26)

Chapter 2 Installation Instructions
19
Serial ATA II Connectors: SATA_1, SATA_2,
SATA_3, SATA_4, SATA_5, SATA_6
The Serial ATA II connector is used to connect
the Serial ATA II device to the motherboard. These
connectors support the thin Serial ATA II cables
for primary storage devices. The current Serial
ATA II interface allows up to 300MB/s data trans-
fer rate.
These six serial ATA connectors support RAID 0,
R A ID 1 , R A ID 5 , R A ID 0 + 1 a n d J B O D
The fan speed can be detected and viewed in
“PC Health Status” section of the CMOS Setup.
These fans will be automatically turned off after
the system enters S3, S4 and S5 mode.
Fan Connectors: CPU_FAN, SYS_FAN, FAN
SYS-FAN
FAN
1
SATA II Connector
GND GND GND
RX+
RX- TX -
TX +
USB Headers: F_USB1, F_USB2
Besides six USB ports on the rear panel, the
series of motherboards also have two 10-pin
headers on board which may connect to front
panel USB cable (optional) to provide additional
four USB ports.
F_USB 1/2
1
5V_DUAL
D-
D+
D-
GND GND
D+
NC Empty
5V_DUAL
Additional COM Connector: COM1 (optional)
This motherboard provides an additional serial
COM header for your machine.
Connect one side of a switching cable to the
header, then attach the serial COM device to the
other side of the cable.
COM1
SOUT
GND RLSD RI#
DTR#
DSR# SIN
9
10
1
2
CTS#
RTS#
Empty
CPU_FAN
+12V GND SENSE
1
SENSE GND
1
POWER CONTROL
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn