Foxconn C51XEM2AA-8EKRS2H User Manual

Page 24

Chapter 2 Installation Instructions

Other Connectors

This motherboard includes connectors for FDD devices, IDE devices, Serial ATA
devices, USB devices, and others.

FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.

IDE Connector: PIDE
The IDE connector supports Ultra ATA 133/100/66 IDE hard disk drives. Con-
nect the cable’s blue connector to the IDE connector, then connect the gray
connector to the slave device (hard disk drive) and the black connector to the
Ultra ATA master device. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the hard
disk documentation for the jumper settings.

Attention:

Ribbon cables are directional, therefore, make sure to always
connect with the cable on the same side as pin 1 of the PIDE or
FLOPPY connector on the motherboard.

PDF 文件使用 "pdfFactory" 试用版本创建