Formax FD 280 User Manual
Page 39
35
To clear mail pieces from the transport tray:
WARNING
DO NOT PLACE FINGERS OR TOOLS BETWEEN
OR NEAR MOVING PARTS.
1. Press the STOP switch quickly
2. Leave the heads in place.
3. Reverse the piece through the FD 280 by turning
the transport rolls by hand. Pull the jammed mail
pieces out of the input area of the transport.
4. If the jam happens upstream from the tab heads, it
may be necessary to remove the transport rolls.
Each set of rolls is spring loaded and is mounted
on a spring loaded shaft. Release spring pressure
and slide the entire roll assembly out of the
machine by compressing the spring on the shaft
and lifting the shaft out once one end is free from
its mounting hole. Note one mounting hole is
shaped like s “D” to prevent the shaft from turning.
Make sure to replace the shaft as you have
removed it.
WARNING
DO NOT PLACE FINGERS OR TOOLS BETWEEN
OR NEAR MOVING PARTS.
9.1.3 Torn Backing
Paper
If the backing paper tears before the drive roll, the
FD 280 will stop tabbing but continue feeding.
To start tabbing:
WARNING
DO NOT PLACE FINGERS OR TOOLS BETWEEN
OR NEAR MOVING PARTS.
1. Turn the POWER SWITCH off.
2. Thread the FD 280 from the point where the
backing paper tore. (Refer to Section 6.1.)