Formax FD 280 - Manual (Page 36)

32
Mail piece has
jammed in machine.
Clear the jam. Refer
to Section 9.1.3.
Backing paper has
torn before the drive
roll.
Thread tabs from that
point on. Refer to
Section 9.1.4.
5. Feeding stops. Accessory fuse is
blown.
Replace blown
accessory fuse. Refer
to Section 3.4. If the
fuse is not blown,
refer to your feeding
device manual.
6. Backing paper
slack.
Backing paper is
threaded under the
drive roll.
Re-thread tabs.
Refer to Section 6.1.
7. Tabbing
incorrectly
Peel plate assembly is
not latched.
Debris and tab residue
at peel and fold point.
Tabs set too close
together
Piece size has
changed without
resetting tab
placement locations
Insert and latch peel
plate assembly.
Thoroughly clean tab
fold and seal rollers
and belts. Remove
all tab debris.
Move lead tab closer
to lead edge.
Reset tab placements
see sec. 6.9
8. Multiple tabs on
mail piece.
Incorrect TAB MODE
selection.
Make Mode selection
for tabs and forms
being run. Section
9.1.2.
9. Tab placement is
inconsistent.
Mail pieces are
feeding crooked.
Make sure mail
pieces feed straight
into FD 280. Refer to
Section 9.2.1.
Backing paper has
torn after the drive roll.
Re-thread backing
paper from drive roll.
Refer to Section
9.1.4.
Tabs Hanging up on
way to tabber.
Make sure that tabs
are being pulled from
the tab source freely.
The FD 280 works
best with no
resistance (slack)
from the tabs.
Tilt the box of tabs.
Remove stack
separators.