Formax FD 280 - Manual (Page 33)

29
2. Pull the FUSE DRAWER out of the POWER
ENTRY CASING. (Refer to Figure 7.1.)
Figure 7.1 Replacing FD 280 Fuses
3. Inspect the FUSES; look for blackened glass,
melted wire or a disconnected wire between the
ends of the tube. If you find any of these
problems in either FUSE, that FUSE is blown and
must be replaced.
4. Pull the blown FUSE from its slot.
WARNING
REPLACE ONLY WITH SAME TYPE AND RATING
OF FUSE. (REFER TO CHART BELOW.)
Selected Voltage Line Fuse Value
100V…………………….1.0A (250V time delay)
120V………………….....1.0A (250V time delay)
220V……………………..0.5A (250V time delay)
240V (or 230V)…………0.5A (250V time delay)