Formax FD 280 - Manual (Page 25)

21
2. Remove the peel bar mechanism by unscrewing the
knurled stainless steel knob located on the side of the
assembly.
3. Thread the strip of backing paper down through the
assembly behind the round bar and over the edge of
the peel bar.
4. Holding the backing paper up against the back of the
mechanism, replace it on the machine using the long
Stainless Steel knob.
5. Run the backing paper up and over the black rubber
roll from behind the roller. To allow space between
the black roller and the red rollers, press the
threading release lever.
6. Bring the backing paper up over the front of the red
roller, taking the slack out of the strip and squaring it
under the various rollers in the paper path. Take care
that the edge of the strip is not caught in the peel bar.
7. Take the strip back over the top plastic guide roller
and attach it to the take up spool. Check for
squareness.
Figure 6.2 Threaded Formax FD 280