Formax Cut-True 27A - Manual (Page 8)

5
4. Press the Back Gauge position block (Fig. 2) on the
keypad to set the back gauge position for desired cut
size. Press Enter.
Programming a Standard Job
1. Press the Edit button on the touchscreen to enter
programming mode (Fig. 3). Select a Job Number
by pressing that block on the screen. Then press
Enter. NOTE: Jobs that are already programmed are
outlined.
The Cut-True 27A has the capacity for up to 99 saved
jobs.
Fig. 4
5. Load paper.
6. Press green enable buttons (Page 4, #17) to activate
paper clamp and cutting blade.
Cut # Back Gauge
Position
Advance After Cut Repeat
Cut
# of
Repeats
2. Press the enter button to access the first cut. Press the back gauge block of cut 1 to set the first cut (Fig. 4).
Fig. 3
Enter
Programmed Jobs
Edit Mode
Fig. 2
Move to the first cut
Enter, and move to next cut
Delete the selected cut
Move to next cut
Move to previous cut
Back gauge block
Back Gauge
Position Block