Adjustment of cut, Oiling – Formax Cut-True 27A User Manual

Page 13

Adjustment of Cut

If you set the initial cut at 18” but only insert paper that is

17”, you need to enter 17” in this space indicated (Fig. 13)

and press the calibrate back gauge icon to confirm the

adjustment.

Fig. 13

Enter number here

Back gauge

calibration icon

OILING

All moving parts with screws should be checked periodically to be sure the screws are tight. They may become loose in

the process of transportation. Users should also check and tighten the screws after more than 200 cutting cycles.

All moving parts should be lubricated and oiled periodically to maintain performance and equipment life. Before lubricat-

ing, these parts should be cleaned to remove paper dust and old deposits of oil and grease.

Press the Tool Box icon, then the lubrication icon and follow the steps outlined on the screen.