Formax Cut-True 27A - Manual (Page 11)

Programming an Advanced Divided Cut
If there are top/bottom borders and/or gutters to be cut
between sections, use the Advanced Divided Cut Mode
(Fig. 9b).
1. Go to Edit mode (Fig. 3) and select a job to be pro-
grammed.
2. Press the enter button to access the first cut.
Press the back gauge block of cut 1 to set the first cut
(Fig. 4).
3. Enter the back gauge position for the first cut (Fig. 8a).
15” will be used for this example.
4. Press the Advanced Divided Cut icon and enter the
following (Fig. 9b):
* The size of the large section(s)
* The size of the small section(s) (i.e. border or gutter)
* The number of sections, including large and small
NOTE: The number must be divisible. For example,
15/5=3 and 10/4=2.50 are both divisible, but
14/6=2.333333333 is not divisible.
5. Press the Save icon (Fig. 9b) to store
these settings.
6. The measurements will automatically be calculated for
the job (Fig. 9c). Press the Save icon to
store the job.
Fig. 9b
Advanced Divided Cut
Size of large section(s)
Total # of sections
Size of small section(s)
Fig. 9a
Fig. 9c
8
Save Button
Save Icon