Formax Cut-True 27A - Manual (Page 6)

DESCRIPTION OF EQUIPMENT PARTS
OVERVIEW
1. Side Gauge with Scale In mm/cm and inches. The indicator on the back-gauge shows the measure-
ment. Fine adjustment is done via the electronic hand wheel (20). Minimum
adjustment is 0.5mm.
2. Back Gauge Operated by the touchscreen control panel or the electronic hand wheel.
Moves the paper stack into the appropriate cutting position.
3. Blade Adjustment Access The blade height can be adjusted up to 2mm by using the adjustment screw.
To lower the blade (+), turn to the left. To raise the blade (-), turn to the right.
NOTE: If the blade is adjusted too low, it will cut deeply into the cutting stick,
damaging not only the stick but the cutting blade. The optimal blade height
is when the last sheet in a stack is cut accurately.
4. Carrier (support) Carries the blade holder and the entire mechanism of the machine.
5. Three Socket Headless Screws Adjustable screws to level the blade for even cutting.
6. Cutting Blade Made of high-quality carbon steel.
7. Blade Holder Holds blade in place. There are five screws for blade positioning, (which
should be set up and released step-by-step following the blade replacement
instructions) and adjusting the blade for even operation.
8. Cutting Stick Plastic stick which protects the edge of the blade during cutting. Can be
repositioned and used on all four sides before being replaced.
9. Cutting Stick Access Slot Insert screwdriver here in order to lift and remove cutting stick.
10. Stand Steel stand with shelf, assembly required.
11. Rear Safety Cover Clear plexi cover is provided for operator safety and helps to prevent dust
buildup.
12. Fuse Panel There are six fuses, as follows:
3
1
10
9
8
7
6
5
4
3
2
11
21
20
12
19
18
16
15
14
17
16
FU1 FU2 FU3 FU4 FU5 FU6 FU7 FU8
10A 10A 10A 10A 2A 2A
22
13