Formax FD 3200 - Manual (Page 54)

3-17
Chapt er 3 Advanced Operation
4-3. Cross fold paper at the desired folding position
This is a method to cross-fold standard or non-standard paper at any desired positions. Standard paper or
non-standard paper is handled in the same way and cross-folded by using a method to register the fold
position as a custom fold.
1
Register custom fold referring to the pro cedures of “3. Custom Folding” (p.3-8).
2
Single-fold the paper in the custom fold mode.
3
Register the single-folded paper again as a custom fold referring to the procedures of
“3. Custom Folding” (p.3-8).
4
Follow steps 2 to 15 of “4-1. Cross fold of standard paper” (p.3-13).
5. Changing the Stacker Roller Height
Some thick and stif paper may not be
output smoothly because the paper may open after folding.
Change the stacker roller height and widen the space for the paper to pass in
the output area.
1
Remove the auxiliary paper output guide.
2
Lift the stacker roller and hold it with hand to move to the [A] position shown in the
igure.
[ A]
After completing folding operations, be sure to return the stacker roller to the standard
position. Leaving it in the raised state will result in poor alignment of ejected paper.