P.2-9) – Formax FD 3200 User Manual
Page 34
2-9
Chapt
er 2 Basic Operation
LTR +0.0/+0.0
Ready
0
13
Press the or key to set the
processing speed.
The default of processing speed is [5]. Folding
misalignment, etc.
may occur depending on
the paper used and folding mode. If so, lower
the processing speed.
When paper jam or abnormal folding occurs by using thin and limsy paper, adjust the processing
speed referring to “Thin paper mode”.
The processing speed can be changed during folding process or in the idling state.
However,
folding misalignment may be caused by changing the processing speed
too much.
When setting the folding mode of B6 size paper to double fold, the operable processing speed is
[4] or more. Even if the processing speed is set to [0] to [3], the processing speed will be changed
automatically to [4] when the test key or start key is pressed.
[
A]
[B]
14
Adjust the position of the paper
receiving tray.
Set to [A] to stack ejected paper diagonally.
Set to [B] to stack ejected paper straight.
Refer to Chapter 3 “6. Stacking the Folded
Paper” (p.3-18).
15
Press the test key.
Perform test folding.
Test folded paper
is not counted in the
number of sheets processed.
If this machine does not start by pressing the test key, automatic detection of paper size may
not function. Check the paper feed guide is set appropriately to the scale of paper size.
length of paper> 16 Check the inish of test folding. Check the last sheet of test folded paper for When folding misalignment occurs, refer to
folding misalignment.
Chapter 3 “1. Correcting Folding Misalignment”
(p.3-1)