Formax 2200 Series - Manual (Page 91)

Operator's Manua l 2200 Series Automatic Setting
Display of Malfunctions
ERROR SHEET GAP
WHEN FEEDING FROM FEEDER
Display of
Malfunctions The machine is equipped with an operator-convenient malfunction detection system.
If malfunctions occur, they are identified by different sensors and the machine is
stopped.
The display gives information on
1. Location of malfunction
2. Cause of malfunction
3. Measures to clear the malfunction
Examples for the identification of malfunctions:
INCREASE SHEET GAP
OR IMPROVE SHEET TRANSPORT
ON REGISTER TABLE
CONTINUE WITH KEY C
REMOVE CAUSE
CONTINUE WITH KEY C
ERROR
SHEET TRANSPORT IN FOLD UNIT II
AT LEAST ONE SHEET WAS DELAYED
REMOVE CAUSE
CONTINUE WITH KEY C
ERROR
PHOTODETECTOR IN INFEED SECTION
FOLD UNIT I IS COVERED
REMOVE DOUBLE SHEET
CONTINUE WITH KEY C
ERROR DOUBLE SHEET
STANDARD FOLDS
FOLD UNIT: 2
WRONG ENTRY
MINIMUM: MAXIMUM:
CHECK
ERROR FOLD UNIT 1
PAPER JAM
DRIVE OR ENCODER
Check whether a paper jam has occurred. If this is not the case,
the malfunction may have been caused by an error in the drive
or the encoder.
If the motor starts briefly and the error display comes on again,
the drive is working correctly. This means that the reason is a
defect in the encoder.
If the motor does not start at all, the drive is defective.
Call a service technician.
CONTINUE WITH KEY C
91