Setting of the suction length - main menu set-up – Formax 2200 Series User Manual

Page 70

Operator's Manua

l 2200 Series

Automatic Setting

Main Menu SET-UP

Suction Length

Setting of the Suction Length - Main Menu SET-UP

Adjusting the suction length for the flat pile feeder is necessary when format and type
of paper of the new job differ considerably from the previous one.
The following rule applies:

Short sheets, light stock:

Short suction length

Long sheets, heavy stock:

Long suction length

If, for instance, very short unfolded sheets are processed, it may happen that two
sheets are fed during one suction cycle.
In this case a shorter suction length should be chosen.
When processing heavy stock, there is a possibility that it is not transported reliably
to the register table. Here the suction length should be increased.

A minimum suction length of 20 mm and a maximum suction length of 250 mm can
be set.

Press key C

The BASIC menu is displayed.

TOTAL:

JOB NO:

OUTPUT:

REMAINDER:

MONITORING:

DOUBLES:
TRANSPORT:

ON
ON

00000

0000

00000000

MONITORING

SAVING

COUNTER

SET-UP

JOB