Formax 2200 Series - Manual (Page 44)

Main Menu SET-UP
Setting the Fold Length - Main Menu SET-UP
The automatic setting of the 2200 Series makes it possible that all stops -
driven by timing belts and servo motors - are set automatically to the position
calculated by the computer.
The fold plates which are not used for a particular folding job are automatically
closed by deflectors and always remain in the fold unit.
The fold plate stops can be set in three different ways:
1. Automatic setting of pre-programmed standard folds
2. Entering the fold lengths individually on the keyboard - Special folds
3. Calling up fold programs from the memory - Job saved
Standard Folds For this type of setting, it is not necessary to make a sample fold by hand and to
measure it. Just enter the required type of fold.
The following standard folds are permanently programmed in the software:
Single fold
Z-fold
2x
Z-fold
4x
Letter
fold Double parallel
fold
Open
gate fold
Operator's Manual 2200 Series Automatic Setting
44