Formax 2200 Series - Manual (Page 21)

Operator's Manual 2200 Series Flat Pile Feeder
Moving the Paper
Stack to Work
Position
When the pile table is loaded, the paper stack must be brought
to the work position.
• Push button (1).
The stack moves automatically to the correct position,
controlled by the stack sensor switch (2).
1
2
3
4
The stack height switch is a capaciti-
ve sensor that reacts to the density of
the paper stack. For this reason the
gap between stack and suction drum
can vary when the paper stack has
reached the work position depending
on the type of paper used.
The gap between stack and suction drum
should be 8 mm.
• Set the gap to 8 mm by turning the setting screw (3).
A scale (4) facilitates this setting.
• Lower the front stop (5) and slide
it against the paper stack.
5
Air and Vacuum
Turn on the pump at the operator panel before setting air and vacuum.
The correct setting for air and vacuum can only be determined by running
a few sample sheets after all adjustments have been completed.
21