Dynex DX-19L200A12 - Manual (Page 29)

Changing channel settings
25
DX-19L200A12
Automatically searching for channels
To automatically search for channels:
1 Press MENU. The Main Menu screen appears.
2 Press or to select Channel, then press or
ENTER. The Channel menu opens.
3 Press or to select Auto Ch Memory, then press
or ENTER. The Auto Ch Memory screen opens.
4 Press or to select Automatic Search, then press
or ENTER. The TV begins memorizing all the
channels available in your area.
It may take from 15 minutes to 30 minutes to
complete memorizing digital cable channels.
Depending on the reception, a bar display may not
advance for several minutes.
Notes:
• Memorizing channels is best accomplished during evening
“PRIMETIME” hours, as more stations are broadcasting digital
signals. Memorizing channels can only be accomplished while a
station is broadcasting a digital signal to set that channel into
memory.
• If you are unsure of the digital channels available in your area, you
may visit www.antennaweb.org to receive a list based on your
address or zip code.
• Should you require further assistance you may call the Dynex
Customer Care Center 1-800-305-2204.
• New digital channels may be added to your area periodically, it is
recommended to perform the “Automatic Search” procedure
regularly.
Memorizing channels
This TV is equipped with a channel memory feature which
lets you skip up or down to the next channel set into
memory, skipping over unwanted channels. Before
selecting channels, they must be programmed into the
TV’s memory. To use this TV with an antenna, set the
Signal Type option to the Air mode. See “Setting the
signal type” on page 24. When shipped from the factory,
this menu option is in the Cable mode.
Adding a new channel to memory
If you find a new digital channel, you can add the new
channel into the channel memory.
To add channels to memory:
1 Tune to the new channel.
2 Press MENU. The Main Menu screen appears.
3 Press or to select Channel, then press or
ENTER. The Channel menu opens.
Lock
Setup
Main Menu
Picture
>>
ENTER :Set :Select
Audio
Channel
CH
Auto Ch Memory
Signal Type Cable
Digital Channel Found : 0
Analog Channel Found : 0
Programming Now
Automatic Search Stop
ENTER :Cancel :Select
CH
Lock
Setup
Main Menu
Picture
>>
ENTER :Set :Select
Audio
Channel
CH
Channel
Add/Delete
DTV Signal
Auto Ch Memory
Ch Label
>>
>>
>>
>>
:Select ENTER :Set
CH
DX-19L200A12_11-0606 MAN_ENG_V1.book Page 25 Thursday, November 3, 2011 10:06 AM