Installation, A. dsr1k mode off, B. dsr1k mode on – DNF Controls ST300-DSR1K User Manual
Page 6
ST300-DSR1K & ST300-DSR1K-T, Slow Motion Controller
Page
6
6
o
o
f
f
2
2
4
4
3. INSTALLATION
Select a. OR b. below.
a.
DSR1K MODE OFF
1)
Plug one end of a 9-conductor, RS422 serial cable into the VTR1, VTR2, VTR3,
OR VTR4 connector on the rear of the SLOW MOTION CONTROLLER. Plug
the other end of the cable into the 9-pin REMOTE connector on the VTR.
2)
Connect the supplied POWER SUPPLY, APX#4108, into the POWER
connector on the rear of the ST300. Plug the Power Supply into an outlet, 90
VAC – 240 VAC.
3)
Select REMOTE mode on the VTR's front panel.
4) Check
the
SETUP MENU prior to using the Slow Motion Controller to confirm
proper Record mode, SLO-MO speed range, and other User settable modes.
OR
b.
DSR1K MODE ON
1)
ST300 INSTALLATION
a)
Connect VTR1 connector on the back of the ST300 to the REMOTE
OUT (Play) connector on the DSR-DR1000 #1.
b)
Connect VTR2 connector on the back of the ST300 to the REMOTE
OUT (Play) connector on the DSR-DR1000 #2.
c)
Connect VTR3 connector on the back of the ST300 to the REMOTE IN
(Record) connector on DSR-DR1000 #1.
d)
Connect VTR4 connector on the back of the ST300 to the REMOTE IN
(Record) connector on DSR-DR1000 #2.
e)
Connect the supplied POWER SUPPLY, APX#4108 into the POWER
connector on the rear of the ST300. Plug the Power Supply into an
outlet, 90 VAC – 240 VAC.
f)
Select REMOTE mode on the VTR’s front panel.
g)
Check the SETUP MENU prior to using the Slow Motion Controller
to confirm proper Record mode, SLO-MO speed range, and other User
settable modes.
2)
DSR-DR1000 SETUP
Select “9-Pin Dual Mode” in the DSR-DR1000 Interface Setup Menu. Refer to
the DSR-DR1000 User Manual.