DNF Controls ST300-DSR1K User Manual
Page 19
ST300-DSR1K & ST300-DSR1K-T, Slow Motion Controller
Page
1
1
9
9
o
o
f
f
2
2
4
4
Function Key
Press
Description
GANG [SHIFT] + [VTR#1]
OR
[SHIFT] + [VTR#2]
OR
[SHIFT] + [VTR#3]
OR
[SHIFT] + [VTR#4]
Individually press the VTR keys to be included in the gang;
the LED above the key will turn on. Press the VTR key again
to remove from gang; the LED above the key will turn off.
Press [ESC] to exit.
The VTR LEDs that are on show the gang.
The flashing LED shows which VTR is currently selected.
GO TO FREEZE
POINT
[SHIFT] + [GOTO]
Search VTR to FREEZE point (last Record Out point).
JOG [JOG]
Select JOG mode and enable the Wheel.
LAST CUE
[LAST CUE]
Step to the previous Cue Point Location.
MARK CUE
POINT
[MARK]
Save the current time in the currently displayed Cue Point.
Per SETUP MENU, the Cue Point Location will advance to
the next Cue Point location or remain the same.
NEXT CUE
[NEXT CUE]
Step to the next Cue Point Location.
PREROLL [PREROLL]
Preroll the VTR to the contents of the currently displayed Cue
Point.
PREROLL
VALUE
[SHIFT] + [PREROLL]
Enter desired Preroll Value. Press [ENTER] to save entry
OR press [ESC] to exit without saving entry.
RECORD [REC] or
[REC] + [PLAY]
Places VTR in the Record mode selected by RECORD
MODE in the SETUP MENU.
REVERSE
SLOMO
[REV]
For T-BAR ONLY – HOLD key to play video in reverse.
RELEASE key to play forward.
REWIND
[RWD]
Press and HOLD to rewind. Release key to stop. Set WIND
Speed in MENU.
SHUTTLE [SHUTTLE]
Select SHUTTLE mode and enable the Wheel.
SLOMO
[SLOMO]
Press SLOMO to slo-mo the VTR. Turn the Wheel or move
the T-Bar to change the play speed.
Press SLOMO to STILL frame OR press any transport key to
exit.
SLO-MO
SPEED PRESET
[SHIFT] + [SLOMO]
For WHEEL ONLY - to preset the slo-mo speed. Turn the
Wheel to select desired speed.
Press [ESC] OR any transport key to exit.
STOP [STOP]
Press once to STILL frame VTR.
Press again to put VTR into STOP mode.
TIME MODE
SELECT
[TIME MODE]
Press to toggle between Timecode (TC), VITC (VT) or Tape
Timer (TM) display modes.