DFI G7B630-B User Manual

Page 54

Hardware Installation

Chassis Open Connector

The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to J13.
Whenever a chassis component has been removed, the sensor
sends signal to J13 alerting you of a chassis intrusion event. To
disable this function, place a jumper cap over J13.

Hardware Monitor for Windows

Install the “Hardware Monitor for Windows” utility. By default, the
chassis intrusion detection function is disabled. When enabled, a
warning message will appear when the chassis is open. The utility can
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the “Hardware Monitor for Windows”
section in chapter 4 for more information.

Ground

Chassis signal

This manual is related to the following products:

G7B630-N G7B330-B rev. AE G7B330-B rev. B BL630-D BL630-DR BL600-D BL600-DR G7B330-BR LT330-B BL330-B BL330-BR G7L331-B G7L331-B-L BL631-D BL100-NE/-PE BL100-PE G5C630-DR CT132-B CT132-BR