Datatek UTM - Manual (Page 49)

U T M U s e r ' s M a n u a l
01/18/08 49
Configuration #4
In this configuration, we explore using the Universal Trunk for interfacing to an existing entity
minus the local DSU.
UTM
SAM8
or
SAM16
Channel
Bank
Telephony
Network
The commands used to configure the Universal Trunk Module are as follows:
dsu type=t1 prof=s0 timing=net tsrate=56 delslot=all addslot=1
trunk type=hdlc phy=dsu modtype=samsl
restore
The above will transport one 56Kbps timeslot to the channel bank via a T1 carrier. This is
“fractional T1” because only a fraction is being used. The Channel Bank then presents a serial
data stream to the SAM8/16.
If a DT-4000 were used in the picture above, the channel bank would not be required.