Datatek UTM - Manual (Page 48)

U T M U s e r ' s M a n u a l
01/18/08 48
Configuration #3
In this example, the Serial interface is used to communicate with a Frame Relay network to a DT-
4000.
UTM
DT-4000
Frame Relay
Network
The commands used to configure the Universal Trunk Module are as follows:
trunk type=fr phy=v35 modtype=samsl dlci=16
Please note that the Frame Relay network would need to be configured to transport the circuit on
DLCI 16 on the UTM side. The DLCI may be different on the DT-4000 side.