Datatek UTM - Manual (Page 44)

U T M U s e r ' s M a n u a l
01/18/08 44
7 ALARMS
Below is an enumeration of the module level alarms presented on the Universal Trunk Console
along with their severity.
Alarm Severity
Remote CC Requested Backplane Reset INFO
Remote CC Requested Reboot in Progress INFO
DKGA EEPROM Failure. MAJOR
Tx Error on 10BaseT. Check Physical Connection. MAJOR
Insufficient Buffers for FRAME RELAY LMI Status Report. MAJOR
Lost Connectivity to Peer IP-DSU. MINOR
Peer Connectivity Established. INFO
User Requested Reboot in Progress INFO
Invalid Login Attempt. MINOR
Invalid Password Change Attempt. MINOR
Gateway Connectivity Established. INFO
SNMP Trap Manager not reachable (ICMP). INFO
ICMP Destination Unreachable Msg Received. MINOR
Tx Error on Serial Trunk MAJOR
Over-Temperature Condition Detected. MAJOR
Over-Temperature Condition Cleared. INFO
High Temperature Condition Detected. MINOR
High Temperature Condition Cleared. INFO
DB contains an Invalid Datakit Trunk Configuration. MAJOR
DTK41 10/100 BaseT PHY #N ‘Link Active’. MINOR
DTK41 10/100 BaseT PHY #N ‘Link InActive’. MINOR
DTK41 Fiber ‘Link Active’. MINOR
DTK41 Fiber ‘Link InActive’. MINOR
7.1 M AJOR A LARMS
A major alarm indicates a serious, service-degrading condition.
7.2 M
INOR
A
LARMS
A minor alarm indicates a secondary or transient error that is not likely to affect overall service
unless multiple minor alarms are issued. In this case, a serious condition exists that may affect
overall system performance
Info alarms