Datatek UTM - Manual (Page 31)

U T M U s e r ' s M a n u a l
01/18/08 31
5.2.8 TACACS+ RADIUS S ERVERS
Syntax: tac < PRI | SEC > [ ipaddr= ]
[ port= ]
[ key=”Encryption Key” | NONE ]
[ ENABLE ]
[ DISABLE ]
The tacplus command is only visible when the unit is logged in. The tac command allows the
configuration of up to two TACACS+ RADIUS servers for the device. the servers are used as a
primary server and a secondary server, although they may be individually disabled.
The < PRI | SEC > syntax specifies which server is to be configured. A server may not be
configured while enabled
The [ ipaddr= ] specifies the IP address of the configured server.
The [ port= ] specifies the TCP port to use when communicating with the server. The
TACACS+ service defaults to TCP port 49, but any port may be specified.
The [ key=”Encryption Key” | NONE ] specifies an encryption key to use. The Encryption key
must be enclosed in double quotes, and the double quotes are not part of the key. If no
encryption is desired, the value of
NONE is used to designate unencrypted service.
The ENABLE command allows this server to be used for service, and prevents further
configuration.
The DISABLE command prevents this server from being used for service, and subsequently
allows configuration.
5.2.9 HELP
Syntax: help
The help or ? command without arguments displays the entire Universal Trunk, command set
and command syntax for the mode (logged out or logged in) the unit is currently in. Individual
command syntax is available when the help command is followed by the command name.
5.2.10 VERSION
Syntax: ver
The version or ver command displays the current software and database revisions of the unit
and is only visible when the user is logged in. The command has no arguments.
5.2.11 REBOOT
Syntax: reboot