Datatek UTM - Manual (Page 25)

U T M U s e r ' s M a n u a l
01/18/08 25
4.2 H
OW TO
I
NSTALL A
N
EW
P
AIR OF
U
NIVERSAL
T
RUNKS
When installing a pair of UTM circuit packs follow the configuration steps below. Note that the
examples given are for BNS-2000 VCS nodes.
From CC type: enter trunk ↵
TRUNK MODULE TYPE [64, dds, hs, pq, sft, swt, t1]:
Enter the trunk type you want to mimic. Refer to the trunk command in the module command
section. In this section, notes on the modtype parameter of the trunk command will help you
make your decision.
MODULE ADDRESS: 78 ↵
SESSION MAINTENANCE TRUNK [yes, no: +(no)]: no ↵
COMMENT [up to 60 chars double quoted]:
"Sample Universal Trunk configuration" ↵
GROUP [up to 8 chars]: utm1 ↵
NUMBER OF USER CHANNELS [1-2042: +(26)]: 200 ↵
The number of user channels should match for both UTMs
LINE SPEED [56k, 64k, 128k, 192k, 256k, 320k, 384k, 448k, 512k, 576k,
640k, 704k, 768k, 832k, 896k, 960k, 1.024M, 1.088M, 1.152M, 1.216M,
1.280M, 1.344M, 1.408M, 1.472M, 1.536M, 1.544M, 1.984M, 2.048M:
+(1.536M’)]:
1.536M ↵
NUMBER OF SECONDS BETWEEN TRUNK ACTIVE TESTS [5-256: +(180)]: ↵
MAXIMUM CONSECUTIVE TRUNK ACTIVE FAILURES [2-10: +(3)]: ↵
ENABLE TRUNK MEASUREMENTS FOR THIS TRUNK [yes, no: +(no)]: yes ↵
CALL SCREENING PROFILE ID [up to 8 chars, none: +(none)]: ↵
‰ Physically insert the UTM (DTK41 or CEY5) I/O Board (Installation Section).
‰ Physically insert and activate the UTM (set faceplate rocker switch to Enabl).
‰ Via the Module command set, configure the UTM (Module Command Section).
‰ Restore the UTM board to service from the Module console.
‰ Restore the UTM board to service from the Node console.
‰ Note that modules can be pre-configured prior to installation (as this example depicts). All
configuration data is non-volatile.