Datatek AIX V5.3 (32/64 bit kernel) - Manual (Page 5)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r A I X – R e l e a s e 1 . 0 . 2 2
11/28/05 Datatek Applications Inc. 5
2 D O C U M E N T A T I O N
Since IP-CommKit behaves like a CommKit Host Interface, you can use the CommKit Host
Interface documentation to find answers to most questions. Specifically, use the CommKit Host
Interface for NCR PCI Computers Installation and Administration Guide. This document follows
the same general outline, i.e., it has the same major sections in the same order. Where there are
changes or additions for IP-CommKit, they are described in the appropriate section of this
document. While NCR computers running MP-RAS are very different from IBM computers
running AIX

releases, IP-CommKit is built from source code that was ported from the release of
the CommKit Host Interface that ran on NCR computers. As a result, much of the information in
the CommKit Host Interface for NCR PCI Computers Installation and Administration Guide
applies to IP-CommKit running on IBM computers.

AIX is a registered trademark of IBM.