Datatek AIX V5.3 (32/64 bit kernel) - Manual (Page 10)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r A I X – R e l e a s e 1 . 0 . 2 2
11/28/05 Datatek Applications Inc. 10
vfy mod
The output should be similar to the report below.
Current Configuration:
DK Board Type ==> TN1009 (CPM-HS) w/Serial# 136.
Service State ==> Out of Service.
Operating Mode ==> Simplex.
Trunk Type ==> IP-DSU Compatible Trunk on 10BaseT Network Port.
IP-DSU Loopback Status ==> Loopbacks are not enabled.
IP-DSU Data Encryption Status ==> Disabled.
Actual IP-DSU Service State ==> Not Connected.
Local MAC Address ==> 0.19.5.84.49.56
Local IP Address ==> utm_ip_address
Subnet Mask ==> subnet_mask
Gateway IP Address ==> gateway_ip_address
IP-DSU Destination IP Address ==> host_ip_address
SNMP Trap Manager ==> Not defined.
Check the address and subnet mask fields that you entered. If they are correct, enter the
following command to restore the UTM to service.
rs